R&S FSW-K7 User Manual page 354

®
R&S FSW-K7
Suffix:
<n>
<m>
Parameters:
<State>
Example:
Manual operation:
CALCulate<n>:MARKer<m>:FUNCtion:PNOise:RESult?
This command queries the result of a phase noise measurement in the Analog Demod-
ulation application.
If necessary, the command activates the measurement first.
Suffix:
<n>
<m>
Return values:
<PhaseNoise>
Example:
Usage:
Manual operation:
11.8.2 Defining Limit Checks
Note that in remote control, upper and lower limit lines are configured using separate
commands. Thus, you must decide in advance which you want to configure. The x-val-
ues for both upper and lower limit lines are defined as a common control line. This con-
trol line is the reference for the y-values for both upper and lower limit lines.
● Configuring Limit
● Managing Limit
● Checking the Results of a Limit
● Programming Example: Using Limit
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
.
Window
Marker
ON | OFF | 1 | 0
*RST: 0
CALC:MARK2:FUNC:PNO ON
Switches on the phase-noise measurement for the marker 2.
See "Phase Noise Measurement State"
See "Switching All Phase Noise Measurements Off"
on page 148
.
Window
Marker
numeric value
The difference between the measured carrier power and the
noise power at the position of the specified (normal) marker.
CALC:MARK2:FUNC:PNO:RES?
Outputs the result of phase-noise measurement of the marker 2.
Query only
See "Phase Noise Measurement State"
Lines..........................................................................................355
Lines............................................................................................ 364
Check................................................................. 366
Lines............................................................ 367
Analyzing Results
on page 148
on page 148
354