Capturing Data And Performing Sweeps - R&S FSW-K7 User Manual

®
R&S FSW-K7

11.5 Capturing Data and Performing Sweeps

MSRA/MSRT operating mode
Note that in MSRA/MSRT operating mode, capturing data is only possible for the
MSRA/MSRT Master channel. In Analog Demodulation application channels, the
sweep configuration commands define the analysis interval. Be sure to select the cor-
rect measurement channel before using these commands.
ABORt
INITiate<n>:CONMeas
INITiate<n>:CONTinuous
INITiate<n>[:IMMediate]
INITiate<n>:REFResh
INITiate<n>:SEQuencer:ABORt
INITiate<n>:SEQuencer:IMMediate
INITiate<n>:SEQuencer:MODE
INITiate<n>:SEQuencer:REFResh[:ALL]
SYSTem:SEQuencer
ABORt
This command aborts the measurement in the current measurement channel and
resets the trigger system.
To prevent overlapping execution of the subsequent command before the measure-
ment has been aborted successfully, use the *OPC? or *WAI command after ABOR and
before the next command.
For details see the "Remote Basics" chapter in the R&S FSW User Manual.
To abort a sequence of measurements by the Sequencer, use the
SEQuencer:ABORt
Note on blocked remote control programs:
If a sequential command cannot be completed, for example because a triggered sweep
never receives a trigger, the remote control program will never finish and the remote
channel to the R&S FSW is blocked for further commands. In this case, you must inter-
rupt processing on the remote channel first in order to abort the measurement.
To do so, send a "Device Clear" command from the control instrument to the
R&S FSW on a parallel channel to clear all currently active remote channels. Depend-
ing on the used interface and protocol, send the following commands:
●
Visa: viClear()
●
GPIB: ibclr()
●
RSIB: RSDLLibclr()
Now you can send the ABORt command on the remote channel performing the mea-
surement.
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
.......................................................................................................................... 294
................................................................................................... 295
................................................................................................295
..................................................................................................296
.................................................................................................... 296
.......................................................................................297
....................................................................................... 298
......................................................................................................299
command.
Capturing Data and Performing Sweeps
..................................................................................297
.......................................................................... 298
INITiate<n>:
294