R&S FSW-K7 User Manual page 210

®
R&S FSW-K7
Commands for the Analog Baseband calibration signal are described in the R&S FSW
User Manual.
Remote commands exclusive to Analog Baseband data input and output
INPut:IQ:BALanced[:STATe]
INPut:IQ:FULLscale:AUTO
INPut:IQ:FULLscale[:LEVel]
INPut:IQ:TYPE
CALibration:AIQ:HATiming[:STATe]
INPut:IQ:BALanced[:STATe] <State>
This command defines whether the input is provided as a differential signal via all 4
Analog Baseband connectors or as a plain I/Q signal via 2 single-ended lines.
Parameters:
<State>
Example:
Manual operation:
INPut:IQ:FULLscale:AUTO <State>
This command defines whether the full scale level (i.e. the maximum input power on
the Baseband Input connector) is defined automatically according to the reference
level, or manually.
Parameters:
<State>
Example:
Manual operation:
INPut:IQ:FULLscale[:LEVel] <PeakVoltage>
This command defines the peak voltage at the Baseband Input connector if the full
scale level is set to manual mode (see
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
........................................................................................... 210
..............................................................................................210
............................................................................................ 210
.............................................................................................................. 211
................................................................................. 211
ON | 1
Differential
OFF | 0
Single ended
*RST: 1
INP:IQ:BAL OFF
See "Input Configuration"
ON | 1
Automatic definition
OFF | 0
Manual definition according to
on page 210
LEVel]
*RST: 1
INP:IQ:FULL:AUTO OFF
See "Full Scale Level Mode / Value"
Configuring the Measurement
on page 69
INPut:IQ:FULLscale[:
on page 94
INPut:IQ:FULLscale:AUTO
on page 210).
210