R&S FSW-K7 User Manual page 124

®
R&S FSW-K7
The units define how the demodulated data is displayed.
Phase Unit
THD Unit (% /
Relative
Phase Unit (Rad/Deg)
Sets the phase unit to rad or deg for displaying PM signals.
Remote command:
UNIT<n>:ANGLe
THD Unit (% / DB)
Sets the unit to percent or DB for the calculation of the THD (in the Result Summary).
Remote command:
UNIT<n>:THD
Relative Unit
Defines the unit for relative demodulation results (see
Settings",
Remote command:
CONFigure:ADEMod:RESults:UNIT
5.7.6 Result Table Settings
Access: "Overview" > "Demod Settings" > "Result Table"
Or: "Meas Setup" > "Demod" > "Result Table" tab
The demodulation results are displayed in the Result Summary table (see also
Summary"
ured.
User Manual 1173.9240.02 ─ 23
(Rad/Deg)................................................................................................. 124
DB).......................................................................................................124
Unit................................................................................................................124
on page 279
on page 280
on page 124).
on page 21). The detectors used to determine the results can be config-
Chapter 5.7.6, "Result Table
on page 282
Configuration
Demodulation
"Result
124