R&S FSW-K7 User Manual page 122

®
R&S FSW-K7
If DC is selected, the phase runs according to the existing frequency offset. In addi-
tion, the DC signal contains a phase offset of ± π.
If AC is selected, the frequency offset and phase offset are automatically corrected,
i.e. the trace is always symmetric with respect to the zero line.
Remote command:
[SENSe:]ADEMod<n>:AF:COUPling
Deviation
Switches between logarithmic and linear display of the modulation depth or the phase
deviation or the frequency deviation.
Remote command:
DISPlay[:WINDow<n>]:TRACe<t>:Y:SPACing
AF Auto Scale
Activates automatic scaling of the y-axis for AF measurements. RF power and RF
spectrum measurements are not affected by the auto-scaling.
Remote command:
[SENSe:]ADJust:SCALe[:Y]:AUTO[:CONTinuous]
5.7.4.2 RF Evaluation
Access: "Overview" > "Demod Settings" > "Scaling"
Or: "Meas Setup" > "Demod" > "Scaling" tab
These settings are only available for RF evaluations and the result summary.
Range..........................................................................................................................123
Ref Level
Auto Scale
Scaling........................................................................................................................ 123
User Manual 1173.9240.02 ─ 23
Position....................................................................................................... 123
Once......................................................................................................... 123
on page 267
on page 251
on page 286
Configuration
Demodulation
122