Programming Example - R&S FSW-K7 User Manual

®
R&S FSW-K7
CALCulate<n>:FEED <Evaluation>
This command selects the evaluation method of the measured data that is to be dis-
played in the specified window.
Note that this command is maintained for compatibility reasons only. Use the LAYout
commands for new remote control programs (see
dows in the
Suffix:
<n>
Parameters:
<Evaluation>
Example:
Table 11-7: <Evaluation> parameter values for the AnalogDemod application
Parameter
'XTIM:AM:RELative'
'XTIM:AM:RELative:AFSPectrum'
'XTIM:FM'
'XTIM:FM:AFSPectrum'
'XTIM:PM'
'XTIM:PM:AFSPectrum'
'XTIM:SPECtrum'
'XTIM:AM'
'XTIM:RFPower'
'XTIM:AMSummary'
'XTIM:AMSummary:RELative'
'XTIM:FMSummary'
'XTIM:FMSummary:RELative'
'XTIM:PMSummary'
'XTIM:PMSummary:RELative'
'XTIM:SUMMary'

11.11 Programming Example

In this example we will configure and perform an analog demodulation measurement to
demonstrate the remote control commands.
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
Display", on page 300).
.
Window
Type of evaluation you want to display.
See the table below for available parameter values.
INST:SEL ADEM
Activates analog demodulator.
CALC:FEED 'XTIM:FM'
Selects the display of the FM signal.
Evaluation
AM Time Domain
AM Spectrum
FM Time Domain
FM Spectrum
PM Time Domain
PM Spectrum
RF Spectrum
RF Time Domain (= RF power)
Result summary
Programming Example
Chapter 11.6.2, "Working with Win-
376