Configuring The Measurement - R&S FSW-K7 User Manual

®
R&S FSW-K7
Manual operation:

11.4 Configuring the Measurement

The following remote commands are required to configure an Analog Demodulation
measurement.
Specific commands:
● Managing Standard
● Configuring the
● Configuring the
● Frequency
● Configuring the Vertical Axis (Amplitude,
● Configuring Data
● Triggering..............................................................................................................256
● Configuring
● Adjusting Settings
● Configuring Standard
11.4.1 Managing Standard Settings
You can configure the Analog Demodulation application using predefined standard set-
tings. This allows for quick and easy configuration for commonly performed measure-
ments.
For details see
on page 51.
For an overview of predefined standards and settings see
Standards and
[SENSe:]ADEMod<n>:PRESet[:STANdard]
[SENSe:]ADEMod<n>:PRESet:RESTore
[SENSe:]ADEMod<n>:PRESet:STORe
[SENSe:]ADEMod<n>:PRESet[:STANdard] <Standard>
This command loads a measurement configuration.
Standard definitions are stored in an xml file. The default directory for Analog Demodu-
lation standards is C:\R_S\INSTR\USER\predefined\AdemodPredefined.
Suffix:
<n>
Parameters:
<Standard>
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
See "Preset Channel"
Settings.................................................................................187
Input.............................................................................................188
Output.......................................................................................... 239
Settings............................................................................................... 242
Acquisition.................................................................................251
Demodulation.....................................................................................267
Automatically........................................................................... 283
Traces................................................................................ 287
Chapter 5.2, "Configuration According to Digital
Settings", on page 379.
..........................................................................188
............................................................................ 188
.
irrelevant
String containing the file name.
If you have stored the file in a subdirectory of the directory men-
tioned above, you have to include the relative path to the file.
Configuring the Measurement
on page 50
Scaling)................................................243
Chapter A.1, "Predefined
...................................................................... 187
Standards",
187