R&S FSW-K7 User Manual page 73

®
R&S FSW-K7
Using the TTL interface allows for considerably higher measurement rates than pure
GPIB control, because the frequency stepping of the R&S FSW is directly coupled with
the frequency stepping of the generator.
For more information on TTL synchronization, see
For an overview of which generators support TTL synchronization see
"Overview of Supported
Remote command:
SYSTem:COMMunicate:RDEVice:GENerator:LINK
GPIB Address / TCP/IP Address
For LAN connections: TCP/IP address of the signal generator
For GPIB connections: GPIB address of the signal generator.
Remote command:
SYSTem:COMMunicate:GPIB:RDEVice:GENerator:ADDRess
SYSTem:COMMunicate:TCPip:RDEVice:GENerator:ADDRess
Reference
Selects the internal R&S FSW or an external frequency reference to synchronize the
R&S FSW with the generator (default: internal).
Remote command:
SOURce:EXTernal:ROSCillator[:SOURce]
Edit Generator Setup File
Displays the setup file for the currently selected
an editor.
Although the existing setup files are displayed in read-only mode in the editor, they can
be saved under a different name (using "File > SaveAs").
Be careful, however, to adhere to the required syntax and commands. Errors are only
detected and displayed when you try to use the new generator (see also
ter 4.7.4.8, "Displayed Information and
For details, see
Frequency Min. / Frequency Max.
For reference only: Lower and upper frequency limit for the generator.
Level Min. / Level Max.
For reference only: Lower and upper power limit for the generator.
User Manual 1173.9240.02 ─ 23
Generators", on page 35.
Chapter 4.7.4.3, "Generator Setup
Input and Frontend Settings
"TTL synchronization"
on page 234
on page 233
Generator Type
Errors", on page 43).
Files", on page 37.
Configuration
on page 42.
Chapter 4.7.4.2,
on page 233
on page 234
in read-only mode in
Chap-
73