R&S FSW-K7 User Manual page 265

®
R&S FSW-K7
11.4.7.2 Configuring the Trigger Output
The following commands are required to send the trigger signal to one of the variable
TRIGGER INPUT/OUTPUT connectors on the R&S FSW.
OUTPut:TRIGger<port>:DIRection
OUTPut:TRIGger<port>:LEVel
OUTPut:TRIGger<port>:OTYPe
OUTPut:TRIGger<port>:PULSe:IMMediate
OUTPut:TRIGger<port>:PULSe:LENGth
OUTPut:TRIGger<port>:DIRection <Direction>
This command selects the trigger direction for trigger ports that serve as an input as
well as an output.
Suffix:
<port>
Parameters:
<Direction>
Manual operation:
OUTPut:TRIGger<port>:LEVel <Level>
This command defines the level of the (TTL compatible) signal generated at the trigger
output.
This command works only if you have selected a user defined output with
TRIGger<port>:OTYPe.
Suffix:
<port>
Parameters:
<Level>
Example:
Manual operation:
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
...................................................................................265
........................................................................................ 265
...................................................................................... 266
.......................................................................266
.......................................................................... 266
.
Selects the used trigger port.
2 = trigger port 2 (front panel)
3 = trigger port 3 (rear panel)
INPut
Port works as an input.
OUTPut
Port works as an output.
*RST: INPut
See "Trigger 2/3" on page 103
.
Selects the trigger port to which the output is sent.
2 = trigger port 2 (front)
3 = trigger port 3 (rear)
HIGH
5 V
LOW
0 V
*RST: LOW
OUTP:TRIG2:LEV HIGH
See "Level" on page 104
Configuring the Measurement
OUTPut:
265