Instrument:rename; Instrument[:Select]; System:preset:channel[:Exec] - R&S FSW-K7 User Manual

®
R&S FSW-K7
Application
TD-SCDMA BTS (R&S FSW-K76)
TD-SCDMA UE (R&S FSW-K77)
Transient Analysis (R&S FSW-K60)
VSA (R&S FSW-K70)
WLAN (R&S FSW-K91)
*) the default channel name is also listed in the table. If the specified name for a new channel already
exists, the default name, extended by a sequential number, is used for the new channel.
INSTrument:REName <ChannelName1>, <ChannelName2>
This command renames a measurement channel.
Parameters:
<ChannelName1>
<ChannelName2>
Example:
Usage:
INSTrument[:SELect] <ChannelType>
Selects the channel type for the current channel.
See also
For a list of available channel types see
Parameters:
<ChannelType>

SYSTem:PRESet:CHANnel[:EXEC]

This command restores the default instrument settings in the current channel.
Use INST:SEL to select the channel.
Example:
Usage:
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
String containing the name of the channel you want to rename.
String containing the new channel name.
Note that you cannot assign an existing channel name to a new
channel; this will cause an error.
INST:REN 'IQAnalyzer2','IQAnalyzer3'
Renames the channel with the name 'IQAnalyzer2' to 'IQAna-
lyzer3'.
Setting only
INSTrument:CREate[:NEW]
ADEMod
Optional Analog Demodulation application.
INST:SEL 'Spectrum2'
Selects the channel for "Spectrum2".
SYST:PRES:CHAN:EXEC
Restores the factory default settings to the "Spectrum2" channel.
Event
Activating Analog Demodulation Measurements
<ChannelType> Default Channel Name*)
Parameter
BTDS TD-SCDMA BTS
MTDS TD-SCDMA UE
TA Transient Analysis
DDEM VSA
WLAN WLAN
on page 183.
Table 11-2.
186