R&S FSW-K7 User Manual page 257

®
R&S FSW-K7
TRIGger[:SEQuence]:LEVel:AM[:ABSolute]
TRIGger[:SEQuence]:LEVel:FM
TRIGger[:SEQuence]:LEVel:PM
TRIGger[:SEQuence]:SLOPe
TRIGger[:SEQuence]:SOURce
TRIGger[:SEQuence]:TIME:RINTerval
TRIGger[:SEQuence]:BBPower:HOLDoff <Period>
This command defines the holding time before the baseband power trigger event.
The command requires the optional Digital Baseband Interface or the optional Analog
Baseband Interface.
Note that this command is maintained for compatibility reasons only. Use the
TRIGger[:SEQuence]:IFPower:HOLDoff
control programs.
Parameters:
<Period>
Example:
TRIGger[:SEQuence]:DTIMe <DropoutTime>
Defines the time the input signal must stay below the trigger level before a trigger is
detected again.
For input from the Analog Baseband Interface (R&S FSW-B71) using the baseband
power trigger (BBP), the default drop out time is set to 100 ns to avoid unintentional
trigger events (as no hysteresis can be configured in this case).
Parameters:
<DropoutTime>
Manual operation:
TRIGger[:SEQuence]:HOLDoff[:TIME] <Offset>
Defines the time offset between the trigger event and the start of the sweep.
Parameters:
<Offset>
Example:
Manual operation:
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
...................................................................... 261
...................................................................................... 261
...................................................................................... 261
.......................................................................................... 262
........................................................................................262
............................................................................. 264
Range: 150 ns to 1000 s
*RST: 150 ns
TRIG:SOUR BBP
Sets the baseband power trigger source.
TRIG:BBP:HOLD 200 ns
Sets the holding time to 200 ns.
Dropout time of the trigger.
Range: 0 s to 10.0 s
*RST: 0 s
See "Drop-Out Time"
*RST: 0 s
TRIG:HOLD 500us
See "Trigger Offset"
Configuring the Measurement
on page 258 command for new remote
on page 102
on page 102
257