R&S FSW-K7 User Manual page 232

®
R&S FSW-K7
Example:
Manual operation:
SOURce:EXTernal:POWer[:LEVel] <Level>
This command sets the output power of the selected generator.
Parameters:
<Level>
Example:
Manual operation:
SOURce:EXTernal[:STATe] <State>
This command activates or deactivates the connected external generator.
Parameters:
<State>
Manual operation:
SOURce:POWer[:LEVel][:IMMediate]:OFFSet <Offset>
This command defines a level offset for the external generator level. Thus, for exam-
ple, attenuators or amplifiers at the output of the external generator can be taken into
account for the setting.
Parameters:
<Offset>
Example:
Manual operation:
Interface Configuration
The following commands are required to configure the interface for the connection to
the external generator.
SOURce:EXTernal:ROSCillator[:SOURce]
SYSTem:COMMunicate:GPIB:RDEVice:GENerator:ADDRess
SYSTem:COMMunicate:RDEVice:GENerator:INTerface
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
SOUR:EXT:FREQ:OFFS 10HZ
Sets an offset of the generator output frequency compared to
the analyzer frequency of 10 Hz.
See "(Automatic) Source Frequency (Numerator/Denominator/
Offset)" on page 75
<numeric value>
*RST: -20 dBm
SOUR:EXT:POW -30dBm
Sets the generator level to -30 dBm
See "Source Power"
ON | OFF | 1 | 0
*RST: 0
See "Source State" on page 74
Range: -200 dB to +200 dB
*RST: 0dB
SOUR:POW:OFFS -10dB
Sets the level offset of the external generator to – 20 dBm.
See "Source Offset"
........................................................................233
Configuring the Measurement
on page 74
on page 74
............................................233
.................................................... 233
232