R&S FSW-K7 User Manual page 215

®
R&S FSW-K7
Parameters:
<Level>
Manual operation:
INPut:DIQ:SRATe <SampleRate>
This command specifies or queries the sample rate of the input signal from the optional
Digital Baseband Interface (see
Parameters:
<SampleRate>
Example:
Manual operation:
INPut:DIQ:SRATe:AUTO <State>
If enabled, the sample rate of the digital I/Q input signal is set automatically by the con-
nected device.
This command is only available if the optional Digital Baseband Interface is installed.
Parameters:
<State>
Manual operation:
11.4.2.6 Setting up Probes
Probes can be connected to the optional BASEBAND INPUT connectors, if the Analog
Baseband interface ( option R&S FSW-B71) is installed.
[SENSe:]PROBe<p>:SETup:CMOFfset
[SENSe:]PROBe<p>:ID:PARTnumber?
[SENSe:]PROBe<p>:ID:SRNumber?
[SENSe:]PROBe<p>:SETup:MODE
[SENSe:]PROBe<p>:SETup:NAME?
[SENSe:]PROBe<p>:SETup:STATe?
[SENSe:]PROBe<p>:SETup:TYPE?
[SENSe:]PROBe<p>:SETup:CMOFfset <CMOffset>
Sets the common mode offset. The setting is only available if a differential probe is
connected to the R&S FSW.
If the probe is disconnected, the common mode offset of the probe is reset to 0.0 V.
For details see the R&S FSW I/Q Analyzer and I/Q Input User Manual.
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
VOLT | DBM | DBPW | WATT | DBMV | DBUV | DBUA | AMPere
*RST: Volt
See "Full Scale Level"
"Input Sample Rate"
Range: 1 Hz to 10 GHz
*RST: 32 MHz
INP:DIQ:SRAT 200 MHz
See "Input Sample Rate"
ON | OFF | 1 | 0
*RST: 0
See "Input Sample Rate"
............................................................................215
............................................................................216
............................................................................... 216
................................................................................. 217
............................................................................... 217
...............................................................................217
................................................................................ 218
Configuring the Measurement
on page 67
on page 66).
on page 66
on page 66
215