R&S FSW-K7 User Manual page 235

®
R&S FSW-K7
Example:
Manual operation:
Source Calibration
The following commands are required to activate the calibration functions of the exter-
nal tracking generator. However, they are only available if external generator control is
active (see
Remote commands exclusive to source calibration:
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:RVALue
[SENSe:]CORRection:COLLect[:ACQuire]
[SENSe:]CORRection:METHod
[SENSe:]CORRection:RECall
[SENSe:]CORRection[:STATe]
[SENSe:]CORRection:TRANsducer:GENerate
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:RVALue <Value>
The command defines the power value assigned to the reference position in the grid
(for all traces).
For external generator calibration measurements (requires the optional External Gen-
erator Control), this command defines the power offset value assigned to the reference
position.
Suffix:
<n>
<t>
Parameters:
<Value>
Example:
Manual operation:
[SENSe:]CORRection:COLLect[:ACQuire] <MeasType>
This command initiates a reference measurement (calibration). The reference mea-
surement is the basis for the measurement normalization. The result depends on
whether a reflection measurement or transmission measurement is performed (see
[SENSe:]CORRection:METHod
To obtain a correct reference measurement, a complete sweep with synchronization to
the end of the sweep must have been carried out. This is only possible in the single
sweep mode.
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
SYST:COMM:TCP:RDEV:GEN:ADDR 130.094.122.195
See "GPIB Address / TCP/IP Address"
SOURce:EXTernal[:STATe]
....................................................................................... 236
..........................................................................................236
........................................................................................ 237
.
Window
irrelevant
*RST:
DISP:TRAC:Y:RVAL -20dBm
Sets the power value assigned to the reference position to -20
dBm
See "Reference Value"
Configuring the Measurement
on page 232).
...................................................... 235
........................................................................ 235
.................................................................. 237
0 dBm, coupled to reference level
on page 78
on page 236).
on page 73
235