Analog Baseband Input Settings - R&S FSW-K7 User Manual

®
R&S FSW-K7
5.3.1.4

Analog Baseband Input Settings

Access: INPUT/OUTPUT > "Input Source Config" > "Analog Baseband" tab
The following settings and functions are available to provide input via the optional Ana-
log Baseband Interface in the applications that support it.
For more information on the optional Analog Baseband Interface, see the R&S FSW
I/Q Analyzer and I/Q Input User Manual.
Analog Baseband Input
I/Q Mode....................................................................................................................... 68
Input
High Accuracy Timing Trigger - Baseband -
Center
Analog Baseband Input State
Enables or disable the use of the "Analog Baseband" input source for measurements.
"Analog Baseband" is only available if the optional Analog Baseband Interface is instal-
led.
Remote command:
INPut:SELect
I/Q Mode
Defines the format of the input signal.
For more information on I/Q data processing modes, see the R&S FSW I/Q Analyzer
and I/Q Input User Manual.
"I + jQ"
User Manual 1173.9240.02 ─ 23
State....................................................................................... 68
Configuration........................................................................................................69
Frequency......................................................................................................... 70
on page 191
The input signal is filtered and resampled to the sample rate of the
application.
Two inputs are required for a complex signal, one for the in-phase
component, and one for the quadrature component.
Input and Frontend Settings
RF........................................................... 69
Configuration
68