R&S FSW-K7 User Manual page 134

®
R&S FSW-K7
Trace 1/Trace 2/Trace 3/Trace 4/Trace 5/Trace
Trace
Detector.......................................................................................................................135
Hold.............................................................................................................................135
Average
Average
Predefined Trace Settings - Quick
Trace 1/Trace 2/Trace 3/Trace 4
Trace 1/Trace 2/Trace 3/Trace 4/Trace 5/Trace 6
Selects the corresponding trace for configuration. The currently selected trace is high-
lighted.
Remote command:
Selected via numeric suffix of:TRACe<1...6> commands
DISPlay[:WINDow<n>]:TRACe<t>[:STATe]
Trace Mode
Defines the update mode for subsequent traces.
"Clear Write"
"Max Hold"
"Min Hold"
"Average"
User Manual 1173.9240.02 ─ 23
Mode................................................................................................................. 134
Mode.............................................................................................................135
Count............................................................................................................ 136
Overwrite mode: the trace is overwritten by each sweep. This is the
default setting.
The maximum value is determined over several sweeps and dis-
played. The R&S FSW saves each trace point in the trace memory
only if the new value is greater than the previous one.
The minimum value is determined from several measurements and
displayed. The R&S FSW saves each trace point in the trace memory
only if the new value is lower than the previous one.
The average is formed over several sweeps.
The Sweep / Average Count
procedures.
6...................................................... 134
Config...................................................................136
(Softkeys)............................................................... 136
on page 289
determines the number of averaging
Analysis
Trace Settings
134