R&S FSW-K7 User Manual page 212

®
R&S FSW-K7
Parameters:
<State>
Example:
Manual operation:
11.4.2.5 Configuring Digital I/Q Input and Output
Useful commands for digital I/Q data described elsewhere:
●
INP:SEL DIQ (see
●
TRIGger[:SEQuence]:LEVel:BBPower
Remote commands for the R&S DigIConf software
Remote commands for the R&S DigIConf software always begin with SOURce:EBOX.
Such commands are passed on from the R&S FSW to the R&S DigIConf automatically
which then configures the R&S EX-IQ-BOX via the USB connection.
All remote commands available for configuration via the R&S DigIConf software are
described in the "R&S EX-IQ-BOX Digital Interface Module R&S DigIConf Software
Operating Manual".
Example 1:
SOURce:EBOX:*RST
SOURce:EBOX:*IDN?
Result:
"Rohde&Schwarz,DigIConf,02.05.436 Build 47"
Example 2:
SOURce:EBOX:USER:CLOCk:REFerence:FREQuency 5MHZ
Defines the frequency value of the reference clock.
Remote commands exclusive to digital I/Q data input and output
INPut:DIQ:CDEVice
INPut:DIQ:RANGe[:UPPer]:AUTO
INPut:DIQ:RANGe:COUPling
INPut:DIQ:RANGe[:UPPer]
INPut:DIQ:RANGe[:UPPer]:UNIT
INPut:DIQ:SRATe
INPut:DIQ:SRATe:AUTO
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
ON | OFF | 1 | 0
ON | 1
The high accuracy timing function is switched on.
The cable for high accuracy timing must be connected to trigger
ports 1 and 2.
OFF | 0
The high accuracy timing function is switched off.
*RST: 0
CAL:AIQ:HAT:STAT ON
See "High Accuracy Timing Trigger - Baseband - RF"
on page 69
INPut:SELect
....................................................................................................... 213
................................................................................... 214
.......................................................................................... 214
............................................................................................. 214
.....................................................................................214
.......................................................................................................... 215
................................................................................................ 215
Configuring the Measurement
on page 191)
on page 258
212