R&S FSW-K7 User Manual page 151

®
R&S FSW-K7
Using a peak as a fixed reference marker
Some results are analyzed in relation to a peak value, for example a carrier frequency
level. In this case, the maximum level can be determined by an initial peak search and
then be used as a reference point for further measurement results.
In the Analog Demodulation application the search limits are not available.
Remote commands:
CALCulate<n>:MARKer<m>:FUNCtion:FPEaks:STATe
TRAC? LIST, see
Peak List
Sort
Maximum Number of
Peak
Displaying Marker
Exporting the Peak
Peak List State
Activates/deactivates the marker peak list. If activated, the peak list is displayed and
the peaks are indicated in the trace display.
For each listed peak the frequency/time ("X-value") and level ("Y-value") values are
given.
Remote command:
CALCulate<n>:MARKer<m>:FUNCtion:FPEaks:STATe
Sort Mode
Defines whether the peak list is sorted according to the x-values or y-values. In either
case the values are sorted in ascending order.
Remote command:
CALCulate<n>:MARKer<m>:FUNCtion:FPEaks:SORT
User Manual 1173.9240.02 ─ 23
Working with Markers in the R&S FSW Analog Demodulation application
TRACe<n>[:DATA]
State............................................................................................................ 151
Mode....................................................................................................................151
Peaks........................................................................................152
Excursion........................................................................................................... 152
Numbers........................................................................................152
List............................................................................................... 152
on page 348
on page 309
on page 348
on page 348
Analysis
151