R&S FSW-K7 User Manual page 217

®
R&S FSW-K7
[SENSe:]PROBe<p>:SETup:MODE <Mode>
Select the action that is started with the micro button on the probe head.
See also:
Suffix:
<p>
Parameters:
<Mode>
Manual operation:
[SENSe:]PROBe<p>:SETup:NAME?
Queries the name of the probe.
Suffix:
<p>
Return values:
<Name>
Usage:
[SENSe:]PROBe<p>:SETup:STATe?
Queries if the probe at the specified connector is active (detected) or not active (not
detected). To switch the probe on, i.e. activate input from the connector, use
INP:SEL:AIQ (see
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
"Microbutton Action" on page 71.
.
1 | 2 | 3
Selects the connector:
1 = Baseband Input I
2 = Baseband Input Q
3 = RF (currently not supported; use "1" with RF Input Connec-
tor setting "Baseband Input I")
RSINgle
Run single: starts one data acquisition.
NOACtion
Nothing is started on pressing the micro button.
*RST:
See "Microbutton Action"
.
1 | 2 | 3
Selects the connector:
1 = Baseband Input I
2 = Baseband Input Q
3 = RF (currently not supported; use "1" with RF Input Connec-
tor setting "Baseband Input I")
Name string
Query only
INPut:SELect
Configuring the Measurement
RSINgle
on page 71
on page 191).
217