®
R&S
FSW-K7
Remote command:
SOURce:EXTernal:FREQuency[:FACTor]:DENominator
SOURce:EXTernal:FREQuency[:FACTor]:NUMerator
SOURce:EXTernal:FREQuency:OFFSet
Result Frequency Start
For reference only: The start frequency for the generator, calculated from the config-
ured generator frequency and the start value defined for the R&S FSW.
Result Frequency Stop
For reference only: The stop frequency for the generator, calculated from the config-
ured generator frequency and the stop value defined for the R&S FSW.
Source Calibration Functions
The calibration functions of the external generator are available only if external genera-
tor control is active (see
Calibrate
Calibrate Reflection
Calibrate Reflection
Source Calibration
Recall............................................................................................................................ 77
Save As Trd
Reference
Reference
Calibrate Transmission
Starts a transmission type measurement to determine a reference trace. This trace is
used to calculate the difference for the normalized values.
For details, see
User Manual 1173.9240.02 ─ 23
"Source State"
Transmission................................................................................................. 76
Short............................................................................................. 77
Open............................................................................................. 77
Normalize....................................................................................... 77
Factor....................................................................................................... 78
Position........................................................................................................78
Value........................................................................................................... 78
Chapter 4.7.4.4, "Calibration
Input and Frontend Settings
on page 231
on page 231
on page 74).
Mechanism",
on page 37.
Configuration
on page 230
76