R&S FSW-K7 User Manual page 195

®
R&S FSW-K7
Manual operation:
[SENSe:]MIXer:FREQuency:STARt?
This command queries the frequency at which the external mixer band starts.
Example:
Usage:
Manual operation:
[SENSe:]MIXer:FREQuency:STOP?
This command queries the frequency at which the external mixer band stops.
Example:
Usage:
Manual operation:
[SENSe:]MIXer:HARMonic:BAND:PRESet
This command restores the preset frequency ranges for the selected standard wave-
guide band.
Note: Changes to the band and mixer settings are maintained even after using the
PRESET function. Use this command to restore the predefined band ranges.
Example:
Usage:
Manual operation:
[SENSe:]MIXer:HARMonic:BAND <Band>
This command selects the external mixer band. The query returns the currently
selected band.
This command is only available if the external mixer is active (see
STATe]
Parameters:
<Band>
Manual operation:
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
See "Handover Freq."
MIX:FREQ:STAR?
Queries the start frequency of the band.
Query only
See "RF Start / RF Stop"
MIX:FREQ:STOP?
Queries the stop frequency of the band.
Query only
See "RF Start / RF Stop"
MIX:HARM:BAND:PRES
Presets the selected waveguide band.
Event
See "Preset Band"
on page 192).
KA | Q | U | V | E | W | F | D | G | Y | J | USER
Standard waveguide band or user-defined band.
See "Band"
Configuring the Measurement
on page 57
on page 56
on page 56
on page 57
on page 57
[SENSe:]MIXer[:
195