R&S FSW-K7 User Manual page 282

®
R&S FSW-K7
CONFigure:ADEMod:RESults:AM:DETector<det>:REFerence:MEAStoref
CONFigure:ADEMod:RESults:FM:DETector<det>:REFerence:MEAStoref
CONFigure:ADEMod:RESults:PM:DETector<det>:REFerence:MEAStoref
Sets the reference value to be used for relative demodulation results to the currently
measured value for all relative detectors.
If necessary, the detectors are activated.
A reference value 0 would provide infinite results and is thus automatically corrected to
0.1.
Suffix:
<det>
Example:
Usage:
Manual operation:
CONFigure:ADEMod:RESults:AM:DETector<det>:MODE <Mode>
CONFigure:ADEMod:RESults:FM:DETector<det>:MODE <Mode>
CONFigure:ADEMod:RESults:PM:DETector<det>:MODE <Mode>
Defines the mode with which the demodulation result is determined.
Suffix:
<det>
Parameters:
<Mode>
Example:
Manual operation:
CONFigure:ADEMod:RESults:UNIT <Unit>
This command selects the unit for relative demodulation results.
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
.
irrelevant
See
CONFigure:ADEMod:RESults:PM:DETector<det>:
on page 281
STATe
Event
See "Meas -> Reference"
.
1: Positive peak; 2: Negative peak; 3: Average of positive and
negative peaks (+/-PK/2); 4: RMS
Detector function used for relative demodulation
WRITe
Overwrite mode: the detector value is overwritten by each
sweep. This is the default setting.
AVERage
The average result is determined over all sweeps.
MAXHold
The maximum value is determined over several sweeps and dis-
played. The R&S FSW saves each result only if the new value is
greater than the previous one.
*RST: WRITe
See
CONFigure:ADEMod:RESults:PM:DETector<det>:
on page 281
STATe
See "Mode" on page 125
Configuring the Measurement
on page 126
282