R&S FSW-K7 User Manual page 241

®
R&S FSW-K7
OUTPut:ADEMod[:ONLine]:AF[:CFRequency] <Frequency>
This command defines the cutoff frequency for the AC highpass filter (for AC coupling
only, see
Parameters:
<Frequency>
Example:
Manual operation:
OUTPut:ADEMod[:ONLine]:PHONes <State>
In addition to sending the output to the IF/VIDEO/DEMOD output connector (on the
rear panel of the R&S FSW), it can also be output to headphones connected on the
front panel (PHONES connector).
CAUTION: To protect your hearing, make sure that the volume setting is not too high
before putting on the headphones.
If you do not hear output on the connected headphones despite having enabled both
general online demod output
and this command, adjust the volume setting.
(Using
Parameters:
<State>
Example:
Manual operation:
SYSTem:SPEaker:VOLume <Volume>
This command defines the volume of the built-in loudspeaker for demodulated signals.
The command is available in the time domain in Spectrum mode and in Analog
Demodulation mode.
Parameters:
<Volume>
Example:
Manual operation:
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
[SENSe:]ADEMod<n>:AF:COUPling
numeric value
Range:
*RST:
OUTP:ADEM:ONL:AF:CFR 100Hz
See "AC Cutoff Frequency"
OUTPut:ADEMod[:ONLine][:STATe]
SYSTem:SPEaker:VOLume
ON | OFF | 1 | 0
*RST:
OUTP:ADEM:PHON ON
See "Phones Output"
Range:
*RST:
SYST:SPE:VOL 0
Switches the loudspeaker to mute.
See "Online Demodulation Output State"
Configuring the Measurement
on page 267).
10 Hz to DemodBW/10 (= 300 kHz for active
demodulation output)
100 Hz
on page 129
on page 241.
0
on page 129
0 to 1
0.5
on page 240
on page 128
241