Ricoh D037 Service Manual page 539

1104 [Fusing Idling Before Job]
001 Environment Thresh
002 Idling Temp:P-Roll
003 Idling Time: BW
004 Idling Time: FC
005 Idling Time: M-Thick: BW
006 Idling Time: M-Thick: FC
007 Paper Feed Temp:P-Roller
008 P.Feed Temp:MThick:P-Roll:BW
009 P.Feed Temp:MThick:P-Roll:FC
010 Fusing Upper Limit Temp
011 Offset: Feed Start
012 Offset: Feed Start: M-Thick
031 Offset:Feed Start:1200dpi
033 Offset: Feed Start: Glossy
1105 [Fusing Temperature] Fusing Temperature Adjustment
(Printing Mode, Roller Type, [Color], Simplex/Duplex)
Roller Type –> Center and Ends: Heating roller, Pressure –> Pressure roller
Paper Type -> Plain, Thin, Thick, OHP, Middle Thick, Special
Fusing Ready Temp.
001
Specifies the heating roller target temperature for the ready condition.
P-Roll Ready Target Temp.
006
SM Appendix
System Service Mode
*ENG
[0 to 2 / 2 / 1 /step]
*ENG
[0 to 160 / 150 / 1 /step]
*ENG
[0 to 10 / 0 / 1 sec/step]
*ENG
*ENG
[0 to 10 / 2 / 1 sec/step]
*ENG
*ENG
[0 to 130 / 50/ 1 deg/step]
*ENG
*ENG
*ENG
[0 to 100 / 15/ 1 deg/step]
*ENG
[0 to 100 / 25/ 1 deg/step]
*ENG [0 to 100 / 10/ 1 deg/step]
*ENG [0 to 100 / 30 / 1 deg/step]
*ENG [0 to 100 / 15/ 1 deg/step]
*ENG
[145 to 155 / 150 / 1 deg/step]
*ENG [140 to 160 / 140 / 1 deg/step]
9-5 D037/D038/D040/D041