Usb Slots; Sd Card Appli Move; Overview - Ricoh D037 Service Manual

Controller Options
D038/D041:
Slot 1 is used for one of the optional applications: PostScript 3, Data Overwrite
Security Unit, PictBridge
Slot 2 is used for installing the Browser Unit, HDD Encryption unit, VM card or for
service only (for example, updating the firmware).

USB Slots

Left-side USB slot [C]: Used for connecting a digital camera (only works if PictBridge is
installed).
Right-side USB slot [D]: Used when installing the optional USB2.0/SD card slot
D038/D041 has two slots. D037/D040 has only one slot (there is no optional
USB2.0/SD card slot for these models).

2.22.2 SD CARD APPLI MOVE

The PostScript3 application and fonts cannot be moved to another SD card.
However, other applications can be moved onto the PostScript3 SD card.

Overview

The service program "SD Card Appli Move" (SP5-873) lets you copy application programs
from one SD card to another SD card.
Slot 1 is used to store application programs. But there are 3 possible applications
(PostScript 3, DOS (DataOverwriteSecurity) unit, PictBridge). You cannot run application
programs from Slot 2. However you can move application programs from Slot 2 to Slot 1
with the following procedure.
Make sure that the target SD card has enough space.
1. Enter SP5873 "SD Card Appli Move".
2. Then move the application from the SD Card in Slot 2 to the SD Card in Slot 1.
Do steps 1-2 again if you want to move another application program.
3. Exit the SP mode.
Be very careful when you do the SD Card Appli Move procedure:
The data necessary for authentication is transferred with the application program from
an SD card to another SD card. Authentication fails if you try to use the SD card after
you copy the application program from one card to another card.
Do not use the SD card if it has been used before for other purposes. Normal operation
D037/D038/D040/D041 2-88 SM