Hdd Encryption Unit (D038/D041 Only) - Ricoh D037 Service Manual

Rev. 02/2009
12. Go into the User Tools mode, and select System Settings> Administrator Tools> Auto
Erase Memory Setting> On.
13. Exit the User Tools
mode.
14. Check the display
and make sure that
the overwrite erase
icon [A] shows.
15. Check the overwrite erase icon.
The icon [B]: This icon is lit when there is temporary data to be overwritten, and
blinks during overwriting.
The icon [C]: This icon is lit when there is no temporary data to be overwritten.

2.22.9 HDD ENCRYPTION UNIT (D038/D041 ONLY)

Before You Begin the Procedure
1. Make sure that the following settings are not at the factory default settings:
Supervisor login password
Administrator login name
Administrator login password
These settings must be set up by the customer before the HDD Encryption
unit can be installed.
2. Confirm that "Admin. Authentication" is on:
[User Tools] > "System Settings"> "Administrator Tools"> "Administrator Authentication
Management"> "Admin. Authentication"> "On"
If this setting is "Off", tell the customer that this setting must be "On" before you can do
the installation procedure.
3. Confirm that "Administrator Tools" is selected and enabled:
[User Tools]> "System Settings"> "Administrator Tools"> "Administrator Authentication
Management"> "Available Settings"
"Available Settings" is not displayed until Step 2 is done.
If this setting is not selected, tell the customer that this setting must be selected before
you can do the installation procedure.
SM 2-101
Controller Options
D037/D038/D040/D041