Installation Of Steering Column Assembly - Toyota MR2 1988 Repair Manual

SR-12
STEERING - Steering Column Assembly
INSTALLATION OF STEERING COLUMN
ASSEMBLY
(See page SR-3)
1. PLACE STEERING COLUMN ASSEMBLY IN
INSTALLED POSITION
(a) Place the steering column assembly with the column
upper cover and temporarily tighten support nuts and
bracket nuts .
.__ _ _ _ _ _ _ _ _ _ _ _ _ ..;:..cs;;.;;.e=7a
(b) Position the steering column assembly so the ends of
SR0990
lower support holes and mounting bolts touch.
2. TORQUE TILT STEERING SUPPORT NUTS AND
BREAKAWAY BRACKET NUTS
Torque the support nuts and bracket nuts.
Torque: 260 kg-em (19 ft-lb, 25 N·m)
3. INSTALL PEDAL BRACKET STAY BOLT
Install and torque the bolt.
Torque: 185 kg-em (13 ft-lb, 18 N·m)
4. CONNECT IGNITION SWITCH CONNECTOR AND
COMBINATION SWITCH CONNECTOR
(a) Align matchmarks on the main shaft, universal joint
and pinion shaft.
(b) Install and torque the two bolts.
Torque: 360 kg-em (26 ft-lb, 35 N·m)