Hitachi Compute Blade 2000 User Manual page 240

Display item
P StopOnError *3
Q NCQ *3
R Drive Powersave *3
S SSD Guard *4
*1 This can be changed only when no disk arrays have been set.
*2 Do not use Set Factory Defaults. This setting must be changed to the recommended values.
*3 Always use the Default setting.
*4 Always use the recommended values.
Place the mouse cursor on a setting item and left-click the
mouse to change the setting values. Or, left-click the
mouse to move the cursor and enter a value from the
keyboard. Click Submit after making the setting.
Display/content
Setting whether to start the
operating system in the event of a
fault at system startup
Enabling or disabling the native
command queuing (NCQ) command
Setting the saving mode to a hard
disk
Setting the solid state drive (SSD)
Guard function
189
Setting/display value **
[Disabled (booting)] / Enabled (not
booting)
[Enabled (valid)] / Disabled (invalid)
[Disabled (invalid)] / Enabled (valid)
[Disabled (invalid)] / Enabled (valid)