Lpar Manager Setting Items - Hitachi CB 520H A1 User Manual

LPAR manager Setting Items

The following table shows LPAR manager setting items required to configure
LPAR manager.
item
Web Console LPAR manager firmware
Bank
Logical Partitioning
IPv4
IPv6
LP communication settings
VNIC System No
Time Zone
Performance tuning options
B-2
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Table B-1 LPAR manager setting items
Setting items Description
Sets 0 to 3
Sets the LP mode
LP IP Set the LP IP address for IPv4 and
Address other items.
Subnet Mask
Default
Gateway
Static Set the LP IP address for IPv6 and
address other items.
IP address
Prefix len
Default
gateway
Address
Stateless
address
Sets the protocol that is used for
communication between LPAR
manager and the management
module.
Sets VNIC System No
*Sets the value which does not
overlap with all LPAR manager(s)
which is containing Compute
Blade Series.
Sets LPAR manager System time
zone
To enable Performance tuning
options, set Enable.
Setting Item List
Support
default
Version
0 01-0X or
later
Depends on 01-0X or
a factory- later
shipments
state
0.0.0.0 01-0X or
later
0.0.0.0 01-0X or
later
0.0.0.0 01-0X or
later
Disabled 02-25 or
later
- 02-25 or
later
- 02-25 or
later
Not used 02-25 or
later
- 02-25 or
later
Disabled 02-25 or
later
IPv4 02-25 or
later
0 01-0X or
later
Depends on 01-0X or
a factory- later
shipments
state
Disabled 02-27 or
later