2: System Environment Setting; Before Operations; Flow Of System Environment Setting - Hitachi VisionBase 8880R Product Manual

2: System Environment Setting

When you install the system or change the system configuration, it is necessary to execute setup operations and to
make configuration settings with the system setup utility. Note that if these settings are not done, you cannot install
or operate your operating system and applications.

Before Operations

Be sure to read this section before conducting system environment settings.

Flow of System Environment Setting

When you initially use the system or after you changed the system configuration (for example, by installing an ISA
board), you need to conduct system environment setting. There are two capabilities provided for system
environment setting, the Setup Menu and the ISA Configuration Utility (ICU), which must be executed in the
following procedure:
Built-in devices must be added or exchanged by maintenance personnel only. Be sure to avoid
removing the cover and installing/removing built-in devices. Otherwise, operation of the equipment
shall not be guaranteed.
Hitachi VisionBase 8880R Server
Create backup disks for the ISA
configuration utility disks
Start of the system environment setting
Turn off the system equipment,
plug off the power cord,
and wait 30 seconds
Change the system configuration
Connect the power cord
with the system equipment,
and turn on power
Execute the Setup Menu
Execute the ISA configuration utility
End of the system environment setting
Ch 2: System Environment Setting
19