HP XP20000/XP24000 Manual page 87

Table 22 Error Codes — Part Code 0605 (continued)
Part Error Error Message
Code Number
0605 56519 The reserved volume setting
of Business Copy,
ShadowImage for Mainframe
or Compatible FlashCopy(R)
is defined. Release the
reserved volume setting of
Business Copy,
ShadowImage for Mainframe
or Compatible FlashCopy(R),
and then retry the operation.
0605 56520 The reserved volume setting
of Auto LUN is defined.
Release the reserved volume
setting of Auto LUN, and then
retry the operation.
0605 56521 The licensed capacity of
some program products will
be insufficient because of the
Add Volume operation.
0605 56524 This function cannot be used
by the storage partition
administrator.
0605 56536 The licensed capacity was
exceeded because of
changing the configuration.
Correct the licensed capacity
on the License Key Partition
Definition window.
0605 57101 An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
0605 58246 This function is not supported.
0605 58258 All the paths to the external
volume are blocked.
0605 58263 No paths will be available,
if you change the setting of
paths.
0605 58330 After Disconnect subsystem
or Disconnect volume is
executed, neither Disconnect
paths nor Check paths can
be executed.
0605 58331 The path requested by
Disconnect paths or Check
paths was not found.
Recommended Action
Release the reserved volume
setting of XP Business Copy,
ShadowImage for Mainframe
or FlashCopy Mirroring, and
then retry the operation.
Release the reserved volume
setting of XP Auto LUN, and
then retry the operation.
Increase the licensed
capacity for the program
products that do not have
sufficient licensed capacity,
and then retry the operation.
Select another window. To
set this function, contact the
storage administrator.
Correct the licensed capacity
with the License Key Partition
Definition window.
If this problem persists, call
HP technical support.
Check whether the
DKCMAIN microcode version
and the SVP microcode
version are mismatched.
Restore the blocked path
status, and then retry the
operation.
Make the setting of the paths
to keep at least one path
available, and then retry the
operation.
Execute Check Path & Restore
Volume instead of Disconnect
paths or Check paths.
If this problem persists, call
HP technical support.
Remote Web Console Error Codes
Severity Failure
Level Level
E 5
E 5
E 5
E 3
W 0
E 2
E 5
E 5
E 5
E 5
E 5
87