HP XP20000/XP24000 Manual page 170

Table 39 Error Codes — Part Code 3305
Part Error
Code Number
3305 1035
3305 1036
3305 1037
3305 1038
3305 1039
3305 1041
3305 1043
3305 1044
3305 1045
3305 1049
3305 1074
170 Remote Web Console for Storage System Messages and Error Codes
Error Message
The SSIDs are not defined. If
this problem persists, call HP
technical support.
The size of the specified
volume is outside the setting
range.
The free space remaining in
the parity group is not
enough to install a
customized volume (CV).
The specified emulation type
of the customized volume
(CV) is a type that cannot be
combined.
A path is defined to the
specified volume.
The CU number and the
LDEV number set in the VLL
operation are the same as
those of other volumes.
An operation is specified for
the uninstalled VDEV.
An error occurred during
SVP processing. If this
problem persists, call HP
technical support.
The specified Subsystem ID
already exists. Specify
another SSID.
An error occurred during
SVP processing. If this
problem persists, call HP
technical support.
The specified CU number
cannot be set.
Recommended Action
If this problem persists, call
HP technical support.
The size of volume that can
be set differs by the type of
emulation.
Check the setting range of
each emulation type, and
then change the size of
volume.
There is no capacity left in
the logical parity group to
create CV. The error does not
occur normally because it is
guarded in the screen. In the
unlikely event that this error
occurs, contact HP technical
support.
The specified emulation type
of CV cannot coexist. The
error does not occur normally
because it is guarded in the
screen. In the unlikely event
that this error occurs, contact
HP technical support.
Check the setting.
Check and correct the
settings. If Volume Initialize
and Make Volume are
specified at the same time,
operate them separately.
Correct the settings, and then
retry the operation.
If this problem persists, call
HP technical support.
Correct the specified content,
and issue the request again.
If this problem persists, call
HP technical support.
Correct the settings.
Severity Failure
Level Level
E 2
E 2
E 2
E 2
E 2
E 6
E 2
E 2
E 6
E 2
E 2