HP XP20000/XP24000 Manual page 366

Table 61 Error Codes — Part Code 7005 (continued)
Part Error
Code Number
7005 68839
7005 68867
7005 68868
7005 68869
Table 62 Error Codes — Part Code 7007
Part Error
Code Number
7007 6012
7007 71 1 1
Table 63 Error Codes — Part Code 7010
Part Error
Code Number
7010 51 15
7010 51 16
7010 51 17
7010 51 18
7010 51 19
7010 5120
366 Remote Web Console for Storage System Messages and Error Codes
Error Message
The command has been
rejected, because the
specified reserved volume is
a volume of XP Thin
Provisioning whose zero data
is being discarded.
The command has been
rejected, because the volume
specified as P-VOL is a
quorum disk.
The command has been
rejected, because the volume
specified as S-VOL is a
quorum disk.
The command has been
rejected, because the volume
specified as the reserved
volume is a quorum disk.
Error Message
An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
Error Message
The volume of S-VOL is
different from specified
P-VOL.
You cannot create another L1
pair, because the number of
L1 pairs exceeds the
maximum.
No MU number is available.
The MU number was not
selected.
No P-VOL is selected.
No S-VOL is selected.
Recommended Action
Wait until the process of
discarding zero data is
completed, and then retry the
operation.
Specify another volume.
Specify another volume.
Specify another volume.
Recommended Action
If this problem persists, call
HP technical support.
If this problem persists, call
HP technical support.
Recommended Action
Check the capacity of P-VOL
and S-VOL. Specify a volume
with the same capacity, and
retry the operation.
You cannot create L1 pair for
the specified P-VOL. Delete
the created L1 pair, and retry
the operation.
You cannot create the
specified pair. Check the
possible number of pairs to
be created.
Select MU number.
Select P-VOL, and operate.
Select S-VOL, and operate.
Severity Failure
Level Level
i 0
i 0
i 0
i 0
Severity Failure
Level Level
E 2
E 2
Severity Failure
Level Level
W 0
W 0
W 0
W 0
W 0
W 0