HP XP20000/XP24000 Manual page 143

Table 34 Error Codes — Part Code 3005 (continued)
Part Error Error Message
Code Number
3005 58466 The specified logical volume
cannot be registered,
because an SCSI path is set
to the logical volume.
3005 58467 The specified volume cannot
be set as a Pool-VOL,
because it exceeds the
licensed capacity.
3005 58468 The emulation type of the
logical volume is incorrect.
3005 58469 The specified logical volume
is being used by another
program product.
3005 58470 The operation cannot be
done, because the usage of
the specified Pool is 100%
(full).
3005 58471 The shared memory for the
V-VOL management area is
insufficient.
3005 58472 Acquisition of the pool
information has failed.
Pool information cannot be
acquired when:
V-VOL management area
is not initialized.
V-VOL management area
is not installed.
3005 58473 An error occurred when
setting the Pool. Check the
error message of the logical
volume(s) in the Pool.
3005 58474 The capacity of shared
memory is insufficient or an
error occurred during SVP
processing.
3005 58475 The PCB for fibre port is not
installed.
3005 58491 A communication time-out
error occurred in the storage
system. Wait for a while, and
then retry the operation.
Recommended Action
Specify another logical
volume.
The current licensed capacity
is insufficient. Purchase a new
license key to increase the
licensed capacity.
Specify another logical
volume.
Specify another logical
volume.
Add some pool-VOL, or
decrease the snapshot data
by restoring or deleting XP
Snapshot pairs.
Install additional shared
memory for the V-VOL
management area.
When the pool information
cannot be acquired, do the
following:
Check the installation
status of the V-VOL
management area, when
the V-VOL management
area is not initialized.
Check the installation
status of the V-VOL
management area, when
the V-VOL management
area is not installed.
Check the error message of
the logical volumes in the
Pool.
Check the amount of free
space in Pool management
block in the Pool window.
Install additional shared
memory if the free space is
insufficient.
Call HP technical support if
the capacity of shared
memory is not insufficient.
Install the PCB for fiber port
and retry the operation.
If this problem persists, call
HP technical support.
Remote Web Console Error Codes 143
Severity Failure
Level Level
E 6
E 6
E 6
E 6
E 6
E 6
E 6
E 6
E 6
E 6
E 3