HP XP20000/XP24000 Manual page 417

Table 74 Error Codes — Part Code 8505 (continued)
Part Error Error Message
Code Number
8505 55016 The value set as the maximum
number of connections to
each SLPR is invalid. SLPR
No:%s
8505 55017 The total of the values
registered as the maximum
number of users that can
connect to each SLPR exceeds
the value set as the maximum
number of connections to the
subsystem.
8505 55018 The number of SSIDs exceeds
the maximum that can be
registered.
8505 55019 An invalid SSID was
detected.
8505 55020 The same SSID is already
registered in a different SLPR.
8505 55021 The specified CU number is
invalid.
8505 55022 An attempt has been made
to either register newly a
CLPR that is already
registered, or delete a CLPR
that is not registered.
8505 55023 An attempt has been made
to either register newly a
SLPR that is already
registered, or delete a SLPR
that is not registered.
8505 55024 Some parity groups are
already registered in a
different CLPR.
8505 55025 The incorrect settings of parity
group are contained.
Recommended Action
Set the correct value for the
maximum number of
connections to the SLPR, and
then retry the operation. If this
problem persists, call HP
technical support.
Set the correct value for the
total of the maximum
allowable user connections,
and then retry the operation.
If this problem persists, call
HP technical support.
Delete the SSIDs that are no
longer necessary, and then
retry the operation. If this
problem persists, call HP
technical support.
Correct the SSID setting, and
then retry the operation. If this
problem persists, call HP
technical support.
Assign a different SSID, and
then retry the operation. If this
problem persists, call HP
technical support.
Specify the correct CU
number, and then retry the
operation. If this problem
persists, call HP technical
support.
Correct the CLPR settings,
and then retry the operation.
If this problem persists, call
HP technical support.
Correct the SLPR settings, and
then retry the operation. If this
problem persists, call HP
technical support.
Specify a different parity
group, and then retry the
operation. If the same
problem persists despite
retrying, call HP technical
support.
Correct the settings of parity
group, and retry the
operation. If the same
problem persists despite
retrying, call HP technical
support.
Remote Web Console Error Codes
Severity Failure
Level Level
E 5
E 5
E 5
E 5
E 5
E 5
E 5
E 5
E 5
E 5
417