HP XP20000/XP24000 Manual page 219

Table 50 Error Codes — Part Code 6005 (continued)
Part Error Error Message
Code Number
6005 6012 An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
6005 6023 The SVP is busy. Please wait
for a while, and then retry the
operation.
6005 8000 A time-out error occurred.
6005 8001 A time-out error occurred.
6005 8100 A time-out error occurred.
6005 8104 The storage system accepted
the request normally,
however the processing
requires some time. Wait for
awhile, and then refresh the
window and confirm the pair
status has been changed
properly.
If the pair status is not
changed after refreshing the
window, check the MCU or
RCU and the condition of the
paths between the MCU and
RCU.
6005 8700 Retry operation.
6005 8701 Logical Path between the
MCU and the RCU is not
active.
6005 8702 The specified volume is not
an M-VOL.
6005 8703 The specified number of Paths
is less than the Minimum
number of Paths on RCU
Option screen.
Recommended Action
If this problem persists, call
HP technical support.
If the same problem persists
despite retrying, call HP
technical support.
Retry the operation. If you get
the same message again,
reboot the computer. If
necessary, call HP technical
support.
Retry the operation. If you get
the same message again,
reboot the computer. If
necessary, call HP technical
support.
Retry the operation. If you get
the same message again,
reboot the computer. If
necessary, call HP technical
support.
Wait for awhile, refresh the
window, and confirm the pair
status has been changed
properly.
If the pair status is not
changed after refreshing the
window, check the MCU or
RCU configuration and the
and the condition of the paths
between the MCU and RCU.
Retry the operation.
A logical path does not exist
between the MCU and the
RCU. Check the path status
on RCU Status dialog box,
and reestablish the paths with
Edit Path.
Refresh the window, and
check whether the specified
volume is a M-VOL.
The number of paths is less
than the minimum number
specified on the RCU Option
dialog box. Check the
number of paths, establish the
minimum number of paths,
and retry the operation.
Remote Web Console Error Codes
Severity Failure
Level Level
E 2
W 3
E 4
E 4
E 4
W 0
i 4
i 4
i 4
i 4
219