HP XP20000/XP24000 Manual page 222

Table 50 Error Codes — Part Code 6005 (continued)
Part Error
Code Number
6005 8728
6005 8729
6005 8730
6005 8731
6005 8732
6005 8733
6005 8734
6005 8735
6005 8736
6005 8737
6005 8738
222 Remote Web Console for Storage System Messages and Error Codes
Error Message
The number of minimum
paths exceeds the number of
normal paths.
An internal error occurred.
Invalid Logical Addresses are
specified.
The existing logical addresses
are not equal.
Too many SSIDs (Only Four
SSIDs are allowed).
The Fibre-XP Continuous
Access function is not
installed in the specified
MCU.
The Fibre-XP Continuous
Access function is not
installed in the specified RCU.
Invalid RCU serial number,
SSID, Link Address or
Controller ID.
The specified RCU or SSID
contains some XP Continuous
Access volume pairs.
An internal error occurred.
XP Continuous Access is not
supported under the MCU
Controller emulation type.
Recommended Action
Take either of the following
actions:
1. Add normal paths, and
then delete the paths.
2. Decrease the number of
minimum paths, and then
delete the paths.
Call HP technical support.
Take either of the following
actions:
1. If you are adding RCUs,
specify the same logical
address.
2. If you are editing paths,
specify the same logical
address as the existing
paths. (See the Edit Path
dialog box.)
The logical addresses of all
existing paths are not the
same. Delete the RCU, and
then re-add it, using the same
logical address as other
existing paths.
The maximum number of
SSIDs (four) has been
entered. Verify that the SSIDs
are valid, delete one or more,
and then retry the operation.
Install the program product
key in the MCU.
Install the program product
key in the RCU.
Check the serial number,
SSID and link address of the
RCU, and set the correct
value. Then retry the
operation. If the same error
occurs, call HP technical
support.
Delete all XP Continuous
Access volume pairs of the
specified RCU or SSID, and
retry the operation.
Call HP technical support.
The emulation type of the
MCU does not support XP
Continuous Access. To use XP
Continuous Access, Call HP
technical support.
Severity Failure
Level Level
i 4
E 4
i 4
i 4
E 4
i 4
i 4
E 4
i 4
E 4
i 4