HP XP20000/XP24000 Manual page 419

Table 74 Error Codes — Part Code 8505 (continued)
Part Error Error Message
Code Number
8505 56527 While another user is logged
into Remote Web Console,
you cannot edit the
information of the SLPR that
the user owns. SLPR No:%s
8505 56536 The installation status of the
SLPR has changed.
Check the installation status
of the SLPR on the license key
partition definition window.
8505 57002 An unknown error was
detected.
8505 58310 Some of the shared memory
of the storage system may be
blocked, or the storage
system is being maintained.
Check the status of the
storage system. If this
problem persists, call HP
technical support.
8505 5831 1 Some of the cache memory
of the storage system may be
blocked, or the storage
system is being maintained.
Check the status of the
storage system. If this
problem persists, call HP
technical support.
8505 58312 The configuration cannot be
changed because the write
pending rate of the intended
CLPR is too high. Wait until
the write pending rate falls,
and then retry the operation.
8505 58313 The configuration cannot be
changed because the
available Cache Residency
Manager size or the number
of Cache Residency Manager
areas in the intended CLPR is
insufficient. Check the Cache
Residency Manager size and
the number of Cache
Residency Manager areas.
8505 58315 A maintenance job is running
in the storage system
(Correction Copy, Drive
Copy, LDEV formatting, LDEV
shredding, and Extent
shredding). Retry the
operation after the
maintenance job is
completed.
Recommended Action
Confirm that no user is
logged into Remote Web
Console, and then retry the
operation.
Purchase a license if the
permitted volume of the SLPR
is insufficient.
If this problem persists, call
HP technical support.
If this problem persists, call
HP technical support.
If this problem persists, call
HP technical support.
Wait until the write pending
rate falls, and then retry the
operation.
Check the Cache Residency
Manager size and the
number of Cache Residency
Manager areas.
Retry the operation after the
maintenance job is
completed.
If LDEV formatting, LDEV
shredding or Extent
shredding is not operating,
call HP technical support.
Remote Web Console Error Codes
Severity Failure
Level Level
E 5
W 5
E 4
E 6
E 6
i 5
i 5
W 6
419