HP XP20000/XP24000 Manual page 26

Table 3 Error Codes — Part Code 0003 (continued)
Part Error
Code Number
0003 1 130
0003 1 131
0003 1 132
0003 1 133
0003 1 134
0003 1 135
0003 1 136
0003 1 137
26 Remote Web Console for Storage System Messages and Error Codes
Error Message
You cannot specify the
default nickname when
setting the nickname of a host
group or a host.
No more host groups can be
set, because the number of
host groups has reached the
maximum (254) that can be
set in a port.
Failed to set the WWN
because the number of
WWNs exceeds the
maximum that can be set in
a port.
Failed to set the host mode
because the number of host
modes exceeds the maximum
that can be set in a port.
Failed to set the path because
the number of paths exceeds
the maximum that can be set
in a port.
An error occurred. If this
problem persists, call HP
technical support.
An error occurred. If this
problem persists, call HP
technical support.
Failed to form a LUSE volume
because the number of LUSE
volumes exceeds the
maximum that can be set in
a disk array subsystem.
Recommended Action
Correct the specified
contents, and request again.
No more host groups can be
set, because the number of
host groups has reached the
maximum (254) that can be
set in a port. Reduce the
number of host groups, and
then retry the operation.
The configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
The configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
The configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
When PORT information
(Fibre Address/Fibre
Topology/Channel Speed) is
set, multiple change
instructions are set to the
same PORT. The error does
not occur normally because
it is guarded in the screen. In
the unlikely event that this
error occurs, contact HP
technical support.
When CHA high-speed mode
is set, multiple change
instructions are set to the
same PORT. The error does
not occur normally because
it is guarded in the screen. In
the unlikely event that this
error occurs, contact HP
technical support.
The configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
Severity Failure
Level Level
E 6
E 6
E 6
E 6
E 6
E 2
E 2
E 6