HP XP20000/XP24000 Manual page 131

Table 32 Error Codes — Part Code 2005 (continued)
Part Error Error Message
Code Number
2005 2015 An error occurred while
connecting to the subsystem.
Wait for a while, and then
retry the operation.
2005 2032 Communication busy. Retry
later.
2005 2082 Processing is disabled
because the host is mounted
or the device is reserved.
1310 2083 The subsystem status is
invalid. Call HP technical
support.
2005 2084 The subsystem status is
invalid. Call HP technical
support.
2005 2098 The operation cannot be
performed, because the SVP
microcode version does not
match the DKCMAIN
(subsystem) microcode
version.
2005 2099 The operation cannot be
performed, because an
inoperative MP exists.
2005 2502 The specified volume cannot
be combined as a LUSE
volume because it does not
Read/Write attribute (S-VOL
enabled).
2005 2503 The LUs cannot be released
because the volumes do not
have Read/Write attribute.
2005 3002 An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
2005 3003 An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
2005 3006 An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
Recommended Action
A communication error
occurs. If the error occurs
after retrying, call HP
technical support.
Retry the operation later.
The host is mounted or the
device is reserved. Unmount
the host, and cancel
reservation of the device. If
the host is an AIX host,
unmount the host, and
execute the varyoffvg
command.
Check the DKC status and the
current status of the
configuration setting. If
necessary, re-execute the
setting operation.
Check the DKC status and the
current status of the
configuration setting. If
necessary, re-execute the
setting operation.
Call HP technical support,
when the same problem
persists.
Wait a few seconds, and
then retry the operation. If the
same problem persists, call
HP technical support.
Correct settings, and then
retry.
Correct settings, and then
retry.
Correct settings, and then
retry.
If this problem persists, call
HP technical support.
If this problem persists, call
HP technical support.
Remote Web Console Error Codes
Severity Failure
Level Level
E 6
E 3
E 6
E 2
E 2
E 6
E 6
E 6
E 6
E 2
E 2
E 2
131