HP XP20000/XP24000 Manual page 401

Table 67 Error Codes — Part Code 8105 (continued)
Part Error Error Message
Code Number
8105 1 127 An error occurred. If this
problem persists, call HP
technical support.
8105 1 128 An error occurred. If this
problem persists, call HP
technical support.
8105 1 130 The specified name is the
same as the system default
name. Change the name.
8105 1 131 Failed to set the host group
because the number of host
groups exceeds the maximum
that can be set in a port.
8105 1 132 Failed to set the WWN
because the number of
WWNs exceeds the
maximum that can be set in
a port.
8105 1 133 Failed to set the host mode
because the number of host
modes exceeds the maximum
that can be set in a port.
8105 1 134 Failed to set the path because
the number of paths exceeds
the maximum that can be set
in a port.
Recommended Action
CHA high-speed mode is
specified to an unmounted
CHA. The error does not
occur normally because it is
guarded in the screen. In the
unlikely event that this error
occurs, contact HP technical
support.
A request has been made to
change to a channel speed
change is requested, but
Fibre PCB does not support
it. The error does not occur
normally because it is
guarded in the screen. In the
unlikely event that this error
occurs, contact HP technical
support.
Correct the specified
contents, and request again.
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
Remote Web Console Error Codes 401
Severity Failure
Level Level
E 2
E 2
E 6
E 6
E 6
E 6
E 6