HP XP20000/XP24000 Manual page 241

Table 50 Error Codes — Part Code 6005 (continued)
Part Error Error Message
Code Number
6005 8938 The Paircreate operation with
the serial remote copy
connection failed because
there are pairs with the Fibre
Channel remote copy
connection in the specified
MCU.
6005 8939 The specified M-VOL cannot
be used.
6005 8940 The operation failed because
the specified R-VOL is in a
Read Only status by Volume
Retention Manager.
6005 8943 The specified volume or other
volume(s) of the same group
in the RCU is being changed
to Simplex/Suspend status.
Retry the operation a few
minutes later.
6005 8944 The specified R-VOL is not
available according to the
attribute of the R-VOL
changed by Data Retention
Utility.
6005 8945 At least one of the following
is invalid:
M-VOL parameters (CU
number, Port, GID, LUN)
SSID or CU number of the
RCU
R-VOL parameters (Port,
GID, LUN)
6005 8947 The external volume that is
mapped to an internal
volume is connected to the
port.
6005 8948 The specified port is receiving
I/O requests.
6005 8949 An internal error occurred.
6005 8950 An internal error occurred.
Recommended Action
Delete all the pairs with the
Fibre Channel remote copy
connection in the specified
MCU, and then retry the
operation.
Check the LUN of the
specified M-VOL by using
RAID Manager, and specify
the LUN with the value less
than 1,024 for the M-VOL.
Confirm the status of the
specified R-VOL.
Refresh the window a few
minutes, later and check the
status of the specified volume
and other volumes of the
same group in the RCU. If it
is possible to perform
operations on the volumes,
retry the operation.
Check the status of the
specified R-VOL.
Verify whether the
parameters of M-VOL, for
example, CU number, port,
GID and LUN, are supported
with the RCU microcode
program version or not.
If you create a pair by using
a LUSE volume, verify
whether or not two or more
CU numbers coexist in P-VOL
and S-VOL.
Specify RCUs of CU Free
when two or more CU
numbers coexist in P-VOL or
S-VOL.
Then, retry the operation with
the correct parameters.
Release the setting of the
external volume, and retry the
operation.
Stop I/O operations, and
retry.
Call HP technical support.
Call HP technical support.
Remote Web Console Error Codes 241
Severity Failure
Level Level
i 4
i 4
i 4
i 4
i 4
W 4
i 4
i 4
E 4
E 4