HP XP20000/XP24000 Manual page 269

Table 54 Error Codes — Part Code 6505 (continued)
Part Error Error Message
Code Number
6505 8731 The existing logical addresses
are not the same.
6505 8733 XP Continuous Access Journal
or Universal Replicator for
Mainframe is not installed in
the subsystem.
6505 8734 XP Continuous Access Journal
or Universal Replicator for
Mainframe is not installed in
the remote subsystem.
6505 8735 The serial number or the
controller ID of the remote
subsystem is incorrect.
6505 8736 The specified remote
subsystem contains journal
groups or data volume pairs
for remote copy operations.
6505 8737 An internal error occurred.
6505 8742 Pinned track(s) exists in the
primary data volume.
6505 8743 Pinned track(s) exists in the
secondary data volume.
Recommended Action
Delete the DKC once, and
then add the DKC using the
same logical address.
XP Continuous Access Journal
or Universal Replicator for
Mainframe must be installed
in the storage system when
you create a path or a pair
for XP Continuous Access
Journal or Universal
Replicator for Mainframe.
Install XP Continuous Access
Journal or Universal
Replicator for Mainframe in
the storage system.
XP Continuous Access Journal
or Universal Replicator for
Mainframe must be installed
in the remote storage system
when you create a path or a
pair for XP Continuous
Access Journal or Universal
Replicator for Mainframe.
Install XP Continuous Access
Journal or Universal
Replicator for Mainframe in
the remote storage system.
Check the serial number and
the controller ID of this remote
storage system and already
registered remote storage
systems, and then specify the
correct values.
If the specified values are
correct, check the cable
connection of the remote
storage system. If the problem
persists, call HP technical
support.
Delete data volume pairs of
the specified remote storage
system. Then delete journal
groups, if any. Ensure that
there are no data volume
pairs and journal groups,
and then retry the operation.
Check the SSB log, and then
call HP technical support.
Check the status of the
pinned tracks in the primary
data volume, and clear the
pinned tracks.
Check the status of the
pinned tracks in the
secondary data volume, and
clear the pinned tracks.
Remote Web Console Error Codes 269
Severity Failure
Level Level
i 4
i 4
i 4
E 4
W 0
E 4
W 4
W 4