HP XP20000/XP24000 Manual page 191

Table 45 Error Codes — Part Code 5205 (continued)
Part Error Error Message
Code Number
5205 1080 The command was rejected
due to one of the following
reasons.
The specified volume was
blocked.
The specified volume was
used as a system disk.
5205 1081 The specified volume(s) are
used as a command device.
5205 1082 The reserved volume(s) is not
equipped.
5205 1083 The specified volume(s) are
already reserved.
5205 1084 The number of reserved
volumes that can be set in the
storage system exceeds the
maximum.
5205 1085 The volume(s) are already
used by Auto LUN.
5205 1086 The RAID level of the target
volume is not supported.
5205 1087 The volume specified as a
migration target is being
formatted.
5205 1088 The volume specified as a
migration source cannot be
migrated, because it is
already used as a reserved
volume of ShadowImage for
Mainframe, XP Business
Copy, or XP Auto LUN.
5205 1094 The volume is not a reserved
volume.
5205 1095 The number of the reserved
volumes exceeds the
maximum number that can be
assigned.
5205 1096 The command has been
rejected, because the volume
specified as a target volume
or a reserved volume is used
by the host.
5205 1 109 Auto LUN does not support
the volume(s).
Recommended Action
Recover the blocked volume,
and then retry the operation.
Also, the system disk cannot
be used as a P-VOL. Specify
another volume.
Release the command device,
or select another volume.
Retry the same operation. If
nothing changes, call HP
technical support.
Retry the same operation. If
nothing changes, call HP
technical support.
The reserved volume cannot
be set.
Retry the same operation. If
nothing changes, call HP
technical support.
Check the microprogram
version, and call HP technical
support.
Retry the operation after the
format is completed.
Specify another volume.
Retry the same operation. If
nothing changes, call HP
technical support.
Retry the same operation. If
nothing changes, call HP
technical support.
Execute the vary offline
command to disable the
volume from the mainframe
host, and then retry the
operation.
Retry the same operation. If
nothing changes, call HP
technical support.
Remote Web Console Error Codes
Severity Failure
Level Level
E 6
E 6
E 6
E 6
E 6
E 6
E 6
E 6
E 6
E 6
E 6
E 6
E 6
191