HP XP20000/XP24000 Manual page 102

Table 26 Error Codes — Part Code 1005
Part Error
Code Number
1005 1002
1005 1003
1005 1004
1005 1005
1005 1007
1005 1009
1005 1010
102 Remote Web Console for Storage System Messages and Error Codes
Error Message
The specified volume cannot
be set as a command device
or a component of a LUSE
volume, because it is being
used as the volume of XP
Continuous Access, Business
Copy, Auto LUN, or XP
Snapshot.
Please select another volume.
You are trying to set multiple
paths to the same volume
from one group.
Multiple volumes are
specified to a single port,
group or LUN combination.
The following volumes cannot
be specified when you
change the path
configurations:
Volumes that do not exist
Volumes other than the top
LUs in expanded LUs
Volumes reserved by Auto
LUN
System Disk volume
Failed to remove the path.
The specified path is the last
path of the volumes used for
XP Continuous Access,
Business Copy, Auto LUN, or
XP Snapshot.
The emulation type of the
volumes is not for open
systems, or the volumes are
not mounted. Check the
setting.
An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
Recommended Action
Select another volume.
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
Check the setting.
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
If this problem persists, call
HP technical support.
Severity Failure
Level Level
E 6
E 6
E 6
E 6
E 6
E 6
E 2