HP XP20000/XP24000 Manual page 396

Table 67 Error Codes — Part Code 8105
Part Error
Code Number
8105 1002
8105 1003
8105 1004
8105 1005
8105 1007
8105 1009
8105 1010
396 Remote Web Console for Storage System Messages and Error Codes
Error Message
The specified volume cannot
be set as a command device
or a component of a LUSE
volume, because it is being
used as the volume of XP
Continuous Access, Business
Copy, Auto LUN, or XP
Snapshot. Select another
volume.
You are trying to set multiple
paths to the same volume
from one group.
Multiple volumes are
specified to a single port,
group or LUN combination.
The following volumes cannot
be specified when you
change the path
configurations:
Volumes that do not exist
Volumes other than the top
LUs in expanded LUs
Volumes reserved by Auto
LUN
System Disk volume
Failed to remove the path.
The specified path is the last
path of the volumes used for
XP Continuous Access,
Business Copy, Auto LUN, or
XP Snapshot.
The emulation type of the
volumes is not for open
systems, or the volumes are
not mounted. Check the
setting.
An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
Recommended Action
Select another volume.
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
Check the settings, and then
retry the operation.
Check the setting.
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
If this problem persists, call
HP technical support.
Severity Failure
Level Level
E 6
E 6
E 6
E 6
E 6
E 6
E 2