HP XP20000/XP24000 Manual page 118

Table 27 Error Codes — Part Code 1010 (continued)
Part Error
Code Number
1010 5053
1010 5054
1010 5056
1010 5057
1010 5059
1010 5070
1010 5071
1010 5099
1010 5822
1010 5823
1010 5867
1010 6509
1010 7060
1010 9012
1010 9013
1010 9014
1010 9015
1 18 Remote Web Console for Storage System Messages and Error Codes
Error Message
No port is specified.
You must map at least one
path to the command device.
The specified LUN does not
exist in the system.
No LUN is specified.
The fibre address is
duplicated.
LUN or CU:LDEV is repeated.
Path setup cannot be
performed because the copy
source is not an open-system
volume.
The specified LUN is the last
path to the command device.
Release the command device.
You entered the wrong item.
It is not updated.
The specified volume cannot
be manipulated because it is
reserved by RAID Manager.
The host mode is invalid.
Specify a correct host mode.
An error occurred in the client
logic.
LUN security for the specified
command device will be
released. Do you want to
continue?
The LUN will be specified as
a command device. Do you
want to continue?
The LUN will not be specified
as a command device. Do
you want to continue?
The port of a PCB in High
Speed mode/MIX mode is
selected. When changing the
parameter of topology or the
parameter of host speed, the
change will be applied to the
PCB in High Speed
mode/MIX mode. Are you
sure you want to continue this
operation?
Recommended Action
Check the content of the
operation.
Check the content of the
operation.
Check the content of the
operation.
Check the content of the
operation.
Check the content of the
operation.
Follow the correct operation
procedure.
Follow the correct operation
procedure.
Check the content of the
operation.
Correct the settings, and then
retry.
Correct the settings, and then
retry.
Release the reserved attribute
of the target volume by using
Data Retention Utility.
Correct the mode of the
target group.
Call HP technical support.
To continue processing, click
[OK]. Otherwise, click
[Cancel].
To change the parameter in
High-Speed mode/MIX
mode, click [OK]. Otherwise,
click [Cancel].
Severity Failure
Level Level
W 5
W 5
W 5
W 5
W 5
W 5
W 5
W 5
W 5
W 5
W 5
W 0
E 2
i 0
i 0
i 0
i 0