HP XP20000/XP24000 Manual page 112

Table 26 Error Codes — Part Code 1005 (continued)
Part Error
Code Number
1005 1906
1005 1912
1005 1918
1005 1921
1005 1922
1005 1926
1005 1927
1005 2005
1005 2009
1005 2010
1005 2013
1005 2015
1 12 Remote Web Console for Storage System Messages and Error Codes
Error Message
The specified volume cannot
be set as a command device
because it is being used as a
V-VOL for XP Snapshot.
The specified volume is a
remote command device, and
therefore the command
device setting or the
command device security
setting cannot be set or
released.
An external volume is
mapped to the external port
to be operated. Delete the
external volume that is
mapped to the external port
to be operated, and then
retry the operation.
The specified volume is not a
LUSE volume.
LDEVs that are not normal are
included in the component of
a LUSE volume.
The path cannot be set to the
specified volume, because
the volume is being used as
a quorum disk.
The specified volume cannot
be set as a command device,
because it is being used as a
quorum disk.
An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
The LDEV is being used by
the host, or an error occurred
during SVP processing.
Recovery processing may
take about 1 minute. Wait for
a while.
An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
An error occurred while
connecting to the subsystem.
Wait for a while, and then
retry the operation.
Recommended Action
Select another volume.
Correct the settings, and then
retry the operation.
Delete the external volume
that is mapped to the external
port to be operated, and then
retry the operation.
Check the volume, and then
retry the operation.
Restore the LDEVs, and then
retry the operation.
Check the setting.
Check the setting.
If this problem persists, call
HP technical support.
If this problem persists, call
HP technical support.
Check if the host is
performing I/O operations on
the target path or volume.
If this problem persists, call
HP technical support.
A communication error
occurs. If the error occurs
after retrying, call HP
technical support.
Severity Failure
Level Level
E 6
E 6
E 6
E 6
E 6
E 6
E 6
E 2
E 2
E 6
E 2
E 6