HP XP20000/XP24000 Manual page 400

Table 67 Error Codes — Part Code 8105 (continued)
Part Error
Code Number
8105 1 1 1 1
8105 1 1 16
8105 1 123
8105 1 124
8105 1 125
8105 1 126
400 Remote Web Console for Storage System Messages and Error Codes
Error Message
An error occurred. If this
problem persists, call HP
technical support.
An error occurred. If this
problem persists, call HP
technical support.
Command device security
cannot be set to the specified
volume because the volume
is not a command device.
An error occurred. If this
problem persists, call HP
technical support.
The command device setting
and the command device
security setting are incorrect.
You cannot do any of the
following to the same volume:
Specify the volume as a
command device and
disable command device
security on the volume.
Specify the volume as a
non-command device and
enable command device
security on the volume.
There are no host groups
where the WWN will be
registered.
A volume set as a command
device cannot be used as a
component of a LUSE volume.
Select another volume.
Recommended Action
A nickname is not specified
when the configuration
change of LUN-Security is
requested. The error does not
occur normally because it is
guarded in the screen. In the
unlikely event that this error
occurs, contact HP technical
support.
You have not specified the
value when registering
WWN, or zero is set as the
WWN value. The error does
not occur normally because
it is guarded in the screen. In
the unlikely event that this
error occurs, contact HP
technical support.
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
The setting method of
command device/command
device security is incorrect.
The following settings are
invalid.
1. Set command device +
Release command device
security
2. Release command device
+ Set command device
security
The error does not occur
normally because it cannot
be modified in the window.
In the unlikely event that this
error occurs, contact HP
technical support.
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
Correct the specified
contents, and request again.
Severity Failure
Level Level
E 2
E 2
E 6
E 2
E 6
E 5