HP XP20000/XP24000 Manual page 260

Table 52 Error Codes — Part Code 6010 (continued)
Part Error
Code Number
6010 9308
6010 9309
6010 9310
6010 931 1
6010 9316
6010 9317
6010 9318
6010 9324
6010 9325
6010 9327
6010 9332
6010 9337
260 Remote Web Console for Storage System Messages and Error Codes
Error Message
You set the same path more
than once. The duplicate
paths are excluded.
All paths which you set have
already been registered. This
operation will terminate
because there is no path
which can be added.
You set the same SSID more
than once. Duplicate SSIDs
are excluded.
All SSIDs which you set have
already been registered. This
operation will terminate
because there is no SSID
which can be added.
Through this operation,
M-VOL status will be changed
to Simplex mode even if the
M-VOL is online to the host.
The destination volume of the
specified volume pair may
contain some inconsistency
because volume copy is not
completed yet. Full volume
initialization is required
before re-using it.
As a result of this operation,
you will not be able to re-start
ERASE R-VOL operation.
The specified operation is
prohibited while the script is
running.
The script is terminated
forcibly.
The monitoring time is over,
but the history file is not fully
updated yet.
This operation is not applied
yet.
The requested operation has
started.
Recommended Action
Because there were
overlapped paths in the
added paths, the overlapped
paths were eliminated. Click
[OK] and continue.
Because all the added paths
overlapped, the operation of
adding paths cannot be
executed. Click [OK] and
continue.
Because there were
overlapped SSIDs in the
added SSIDs, the overlapped
SSIDs were eliminated. Click
[OK], and continue.
Because all the added SSIDs
are overlapped, the
operation of adding SSIDs
cannot be executed. Click
[OK], and continue.
Follow the instructions in the
message.
Follow the instructions in the
message.
To delete the pair, even
though you cannot re-execute
the R-VOL deletion, click
[OK]. If not, click [Cancel].
Try again after the script
ends.
Click [OK].
Click [Refresh] to update the
history file. If this problem
persists, call HP technical
support.
Click [OK], and then continue
the operation.
The requested operation has
started. Click [OK] to close
the dialog.
Severity Failure
Level Level
W 0
W 0
W 0
W 0
W 0
W 0
W 0
W 0
i 0
i 0
i 0
i 0